Sunday, July 1, 2012

Squirrel Creek Fire (Day 1)

The fire broke over the ridge up the road at 4:30PM.
The Squirrel Creek Fire started on Saturday June 30th about five miles from the house.  Overnight it was estimated to have burned 70 acres.  By the afternoon of the July 1st it was over 2000 acres in size.  Around 4:15 PM the fire broke the ridgetop visible in this photo.  As the crow flies, it's eight tenths of a mile from the house to the ridge where you can see the flames.  Four hours later it burned down the slopes around the house.  The fire truck in the photo above is from the Centennial Valley Volunteer Fire Department.  Later in the evening, crews from the Forest Service took over the defense.  Scott Davis, the Albany County Fire Commissioner assured me that the house was defendable and said that although he could not give any guarantees, he was sure the house would be standing after the fire went through.  It was.


Firefighters arrive to defend the house.


The main factors contributing to the defensibility of the house are the metal roof, the stucco siding and the fact that there is a good buffer zone from the house itself to the sagebrush.   I mowed the tall native grass away the from the house.  We worked hard to grow that grass, but it'll come back. The wooden deck is no asset in a fire situation but it can be, and was, watered down to prevent it from burning.





 Randall and I evacuated the immediate area to watch from a safer distance after the trucks were in place around the house.  You can see him driving out in his VW camper in the bottom photo of the series.  We dropped his bus at Woods Landing and drove up to the observatory on top of Jelm.

View from Jelm observatory - house in lower left of photo.

By the evening, the fire had grown from 70 acres to around 2000 acres.

When wind started blowing the smoke eastward toward Jelm we couldn't see anymore (and could not breath) so we drove down the mountain only to find a rather frantic evacuation of Woods Landing underway. Randall furtively slipped into his VW bus intending to stay in Woods Landing overnight. He did end up sleeping the night there - after videotaping the nighttime defense of Woods Landing against the fire.  I moved to a high point along Hwy 230 which allowed me to look down the canyon toward the house. Unfortunately, from where I watched, I was not quite able to see the house itself.

Looking west from the bench above HWY 230.
The fire broke the ridge above the house and burned down the sage slopes above the house.  When the fire got into the steep draws filled with pines and aspens it flared up dramatically.
The two videos included here were taken almost a mile from the house. The one above was shot at about 7:40 PM and the one below was shot around 8 PM.
As the fire came over the rim the wind came up.  Until you've actually seen a fire run through old sagebrush it's hard to imagine how violently it can burn.  Sage is filled with volatile oils that are highly flammable. 
The fire burned down through a steep draw behind my house - 100' flames?
When the wind came up the fire roared across the flats toward Woods Landing - a wall of flames at least 30' high jumped HWY 230 and burned up to the Laramie River.  I could not see Woods Landing itself, just a red glow in that direction.  At the time, I was certain that Woods Landing itself had been lost, it wasn't.
Looking towards Woods Landing as the fire raced across the flats driven by high winds.
Eventually, I drove back up the road so I could see the house.  There were two trucks and a crew of twelve men there. By then the wind had died and the fire had settled down for the evening.  I realized the house was going to survive so I drove into town to spend the night with friends.





More Railing Work



Railing goes in.
 It was a waiting game on the fire until mid-afternoon.   While we waited, Randall and I worked on putting up the railing - well mostly him. I spent time mowing grass around the house, emptying gas cans (into my truck) moving propane tanks etc.


Deck wetted down.
By 3:30 we'd cleaned everything off the deck and wetted it down in anticipation of the fire breaking the ridge top.  There is an account of the evening in the post Squirrel Creek Fire (Day 1).
I am referring to June 30 as "Day 0" and July 1st as "Day 1" of the fire.

Saturday, June 30, 2012

Rust Patina for the Deck Railing & Fire Starts



Randall and I built the deck on the house last summer and a year later the railing is nothing more than sections of 2x4 nailed from post to post.  We've had a year to think about it.  When sitting on the deck, a major component of the view is the cottonwoods which are low down, so a major design goal for the railing was that it block the view as little as possible.  We looked at wire railings which are held by turnbuckles, but they seemed a bit too modern with respect to the rest of the house.  We'd pretty much decided that a plain metal railing would be best.  Another design goal for the railing was to have them match the rusted roof if possible. Ideally this meant a rust patina, but we also thought of finishing it with paint.  Building a rust patina was an experiment that turned out pretty well.


Contro II, Gerald DiGuisto, 1978

As an undergraduate in college I studied with the sculptor Gerald DiGuisto. Gerry was  trained at the Boston Museum School and at Yale. He was a perfectionist regarding every aspect of his work. This perfectionism included the process of constructing the subtly nuanced layers of rust patina on his work.  It was pure alchemy and his formulas were guarded secrets. Memories of Gerry griped me as I tried to figure out a formula for rusting the new railings.


The metal railings were welded up in Fort Collins by Randall's friend Rick at Flash Portable Welding. Once we had selected the plain 1/4" bar stock we left the details of the spacing of up to Randall and Rick.  As soon as I saw them I knew they were perfect.   There is plenty of information on the web about rusting metal.  We ended up with the following process:
  1. Degrease at the car wash using engine cleaner.
  2. Sprayed with muratic acid (diluted 3 cups acid/ gallon of water)
  3. Sprayed with  1/4 cup salt, 1/4 cup vinegar, 1 pint Hydrogen Peroxide
I got impatient and repeated steps 2 and 3 all in the same day. I have no idea what Gerry did to achive such beautiful patinas on his work.







By the end of the day we had a nice rust patina on the railings. Unfortunately, this was also the day we first saw smoke from what became the Squirrel Creek Fire.



After working on hte railings all day, I loaded up one car with important papers and valuables and drove it to town. Friends there drove me back out to the house with a horse trailer in tow and we loaded a number of large pieces of furniture for them to take back to town.

Thursday, November 24, 2011

Thanskgiving Day

A view from across the canyon.

Returning from the hike.

Friday, October 28, 2011

Sunday, October 16, 2011

Fall Color

Front door leads down a hallway to the door onto the deck.

The rust patina on the roof is getting deeper.

Erdos studying the cottonwoods.